ULTRASTOR CORPORATION ULTRA12F24 Data bus: 16-bit, ISA Size: Three/Quarter-length, full-height card Hard drive supported: Two ESDI drives Floppy drives Two 360KB, 720KB, 1.2MB, or 1.44MB supported: [Image] CONNECTIONS Function Location 34-pin data cable connector-floppy drive J1 20-pin data cable connector-drive 1 J3 20-pin data cable connector-drive 0 J4 34-pin control cable connector-hard drive J5 4-pin connector-drive active LED J6 BIOS ADDRESS Address JP10/A JP10/B JP10/C Disabled open open open » C800h open open closed CC00h open closed open D000h open closed closed D400h closed open open D800h closed open closed DC00h closed closed open Disabled closed closed closed USER CONFIGURABLE SETTINGS Function Location Setting » Factory configured - do not JP4 pins 1 & 2 alter open » Cache enabled JP4 pins 3 & 4 open Cache disabled JP4 pins 3 & 4 closed » Third drive support with a JP11/A open double twisted cable Third drive support with a JP11/A closed single twisted cable » Floppy Drive 1 is a 3.5 or 5.25 JP11/B open AT floppy Floppy Drive 1 is a 3.5 PS/2 JP11/B closed floppy » Floppy Drive 0 is a 3.5 or 5.25 JP11/C open AT floppy Floppy Drive 0 is a 3.5 PS/2 JP11/C closed floppy » Floppy primary port address is JP11/D open 3F0-3F7h Floppy secondary port address is JP11/D closed 370-377h » Single speed floppy drive JP11/E open support Dual speed floppy drive support JP11/E closed » Precompensation varies: 250ns, JP11/F open 208ns, 125ns Precompensation set to 125ns JP11/F closed » Hard disk primary I/O address is JP12 open 1F0-1F7 Hard disk secondary I/O address JP12 closed is 170-177h » Floppy drive enabled JP17 closed Floppy drive disabled JP17 open » Interrupt is IRQ14 JP20 pins 2 & 3 closed Interrupt is IRQ15 JP20 pins 1 & 2 closed DRAM CONFIGURATION NOTE Note: The ULTRA12F24 is installed with 32KB of cache.